The Good Time Magnetic Bar Holder is the perfect in-shower storage solution for all of your Good Time bars. It’s a sleek, semi-permanent wall fixture that requires no shelf space and is functional as it is stylish.
The magnetic rail and button attachment system allows for 360° ventilation of bars between uses, effectively preventing them from becoming soggy and mushy. Each rail holds up to three bars and the colorful metal buttons can be used to distinguish bars from each other. Enjoy long lasting bars and add additional rails to your shower to store our full range of plastic-free products.
What's included?
- 1 Magnetic Bar Holder with 3M adhesive strip
- Materials: silicone, magnets, steel, adhesive; Dimensions: H 2.5cm x W 17.7 cm x D 1.2cm
- 3 bar buttons
- Materials: powder coated steel; Dimensions: diameter 2.5cm, H 8.3mm
- 1 alcohol pad (for installation)
How it works
After installing the silicone rail onto your wall with the semi-permanent adhesive strip (read more about installation here), press one of the included metal buttons into the center of the back side of a bar until it lies flush with the bar surface. Align the attached button with one of the circular divots on the rail to magnetically secure it.
Usage tips
- If you’re installing more than one Magnetic Bar Holder, allow for a little space (about 10cm/4in) between them — this allows for your bars to hang comfortably.
- As your bars get smaller over time, give your button a little press to ensure it stays in place.
- The Magnetic Bar Holder was designed specifically to support Good Time products. However, some softer bars (like our Hydrating Conditioner Bar) may be more likely to detach from the magnetic button. If it does, no worries — just reinsert the button or move it to the opposite side of the bar.
- If needed, the silicone casing can be removed from the metal backing to clean either piece. Reattach the silicone casing by aligning the two grooves along the long edges of the silicone casing with the edges of the metal brackets and press on firmly.
How do I remove the bar holder from my wall?
- If possible, apply heat from a hair dryer for about 3 minutes directing heat to the adhesive area of the rail.
- Starting from one end, use a scraper or flat-head screwdriver to gently pull the rail away from the wall.
- Safely use a flat edge to detach exposed adhesive when pulling forward.
- Continue slowly pulling the rail away from the wall.
- Once the rail is removed, slide a finger over any adhesive residue to roll it off the wall and continue until all is removed.
Surface Guide Recommendations
- Recommended for:
- Ceramic/matte flat tiles
- Shiny flat tiles
- Shiny fiberglass
- Sealed marble
- Glass
- Not suitable for:
- Textured/uneven tiles
- Natural, unsealed stone
- Slatted surfaces
- Wood
- Concrete
- Mosaic tiles
Warnings
Avoid sharp edges. Not suitable for children under 3 years. Choking hazard due to small parts.