Installing the Magnetic Bar Holder

 

Step 1: Prepare

Pick a spot on the wall of your shower that’s outside the regular water stream. Wipe the surface with the included alcohol pad and allow it to dry completely.

Step 2: Stick

Note to perfectionists: since the Magnetic Bar Holder is semi-permanent, you might want to use a level for this next part.

Remove the liner on the Magnetic Bar Holder’s adhesive strip. Press bar holder firmly on the dry shower wall and hold for 30 seconds.

Step 3: Wait!

This part’s important: do not turn on the shower or attach bath bars for 24 hours while the adhesive works its magic.

Step 4: Attach

After 24 hours, firmly press a button into the centre of the back of your bath bar until it is flush with the product. Connect the bars to the holder by aligning the magnetic buttons to the divots on the bar holder.

Step 5: Enjoy!
Was this article helpful? 0 out of 2 found this helpful